SPID remote antenna commutator at 8 ways

The waterproof external unit is in a stainless steel housing. For the connection between the controller and the external unit, a 9 pin cable is required.  {

The controllor can be connected directly to the network. The manual switching is made simply by a short pressure on the button at the front of the controller. {

The switch can manage 2000W of power up to a 30mHz throtze. {

unused antenna entrances are s massa. {

This remote switch can be fully automatic. 
for this purpose, the controller has two doors on the rear panel. One is a 25 -pin printer port for direct and control connection via PC (automatically from the software provided and "Spidlog") and the other is a USB interface. This interface is not just for a PC, the switch can be controlled directly by a transceiver. In this case, the switch can automatically select depending on the antenna port pre -selection band. 
In addition to automatic and manual switching, the selection of connection can also be made by a mouse (included). For this, a separate door is provided on the back of the controller. {

Included in Delivery:

• Switch 8: 1
• controller {
• Centronics Cabel {
• CD-ROM (Manual and Software)