Right patrol mk4

The DX-Patrol is a software Defined Radio Received (SDR) with a wide range of reception frequency. In contrast with the usual convenient USB sticks DVB-T receiver has an additional short wave converter. This is the reason for the wide frequency range from 100 KHz to 2000mHz. For operation with the HF converter, additional bandfilters are provided, with consequent much better dynamic range and good strong performance of the signal management. {

For HF operation, a frequency shift of -40mhz must be set. {

excellent as Panadapter See this link: https://youtu.be/esvwvc9cuos

Another feature is that the entire frequency range is provided without gaps. With two independent antenna connectors (SMA) it is always possible to use the most suitable antennas without reconnecting when changing the bands. A small switch on the side of the receiver checks a low noise diode diode switch when going from HF VHF or vice versa. The current state (HF / VHF) is shown with a multicolored LED. The maximum sampling rate supported by the hardware is 3.2ms / s, but this is usually limited by the software. The result is a range of sampling frequencies 96 kHz up to approx. 1 MHz, depending on the software. {

Functioning of the DX Patrol SDR receiver is possible with any software that supports DVB-T stick based RTL2832. Possible programs are (among others):

• {
• SDR # (Windows) {
• HDSDR (Windows) {
• sdr-radio.com (Windows) {
• sdr touch (Android) {
• Gnu Radio (Linux) {
• and more {

Programs for special use such as RTL1090 ​​or DUMP1090 can be used to receive the ADS / FARRI B sent by the planes. With this receiver, adequate software and a more suitable cable antenna, a view of the current air situation is easily possible in the reception position. In addition, it is possible to participate in networks that provide real -time flight data on the website such as Fleightradar24.com. Other software allows the reception of low orbit satellites noaa weather out of 137mhz - The possibilities of the LSDR PAP RECEIVATOR PATER are infinite! {

The installation of the DSP patrol DX receiver is simple. It is recommended not to use Windows USB drivers,But those provided through Installer the 'Zadig'. Most of the above programs are free software products, you will find the installation instructions on the various websites of authors of the program. Software just or drivers are not supplied with the receiver. The connection to the computer takes place with USB, a USB-Mini-B USB-A USB-A CONEctor cable is required. Thsi cable is not included.

• {

  History of the versions of the SDR receiver DX-Patrol

• Mk1 changes → MK2
• improved filters;
• Part project Improved HF.
• MK2 changes → MK3
• Two micro USB connectors for OTG support. A power connector, a connector for connecting to the computer or smartphone.
• Micro USB cable (OTG) included, allows the use of a smartphone;
• Sensitivity in VHF/UHF improved.
• Mk3 changes → MK4 V1
• Range Selection HF/VHF via software
• On/off Switch
• Solid Metal Houses
• MK4 V1 changes → MK4 V2
• On/off Switch was eliminated
• Only One Micro-USB Socket for Data + Power
• Led on the other side of the case

English manual DXPATROL-SDR_MK3.PDF

Software SDR# Rev 1427 & Amp; ADSBSPY

driver Compatibility Driver