mat-30 tuner for Yaesu devices

{

Mat is a supplier from China, which specializes in the production of antenna tunnels. The company is managed by expert radio amateurs and aims to develop a wide range of high -quality and convenient automatic antenna tanks. Most devices can be supplied and controlled fully automatically from the radio via a control cable. Wimo started selling these tunnels after numerous tests in the spring of 2019.

{

The Mat-30 is an automatic tuner for the range of frequencies from 1.8 to 54 MHz. The tuner is compatible with a variety of Radio Yaesu. Therefore it can be used on all Yaesu transceivers that can use Yaesu FC-30, FC-40 or FC-50 tuning. These are among other models: FT-100, FT-857D, FT-897D, FT-450D, FT-891, FT-950, FT-991 (A). A suitable control cable is included for the cat of the radio. This cable is also used for power. {

The MAT-125E tuner stores the tuning settings found by frequency in a memory. There are 16,000 memory positions available for this purpose. If a well -known frequency is used again, the setting is read by the memory and the optimization process is completed in less than 0.2 seconds. If a new frequency is used or if a new frequency must be tuned (and stored), the process requires max. 5 seconds. During the tuning process, the transmitter is offered an Max switch. 2: 1 to protect the radio output stage. {

The operation takes place via the "Tune" button on the radio. This simplifies the tuning process by automatically switching to low power and CW mode, as well as moving on to the method and transmission power previously used. The minimum tuning power is 1 W, it is possible to use a maximum of 120 W PEP, with RTTY and other continuous wave modes of about 30 W max. The tuner tunes the antennas in an impedance interval from approx. From 5 to 1500 Ohm, which is much more than the usual integrated tunnels can manage. {

• {
• Delivery volume

• {
• MATT-30 tuner

• Yaesu control cable (2x minidin 8 pin