Balstar at 2k manual tuner 2000 watt

{

The tupering tuner AT- 2K is a tuner of short wave manual antenna and 6m. Using the three checks (2x variable capacitor, 1x roller inductor) you get very accurate and precisely reproducible tuning results. Varicap are tuned through a 6: 1 reduction, the smooth roller inductor execution through a large crank. These components must therefore at its maximum permitted transmission power of 2000W PEP, a very high resistance. ENROLCE VARTS 20-1500 Ω for frequencies 1.8-30 MHz, the 6M impedance is a little less. {

{

Connect with the way of passing two different antennas or directly or via the tuner to the transceiver. An additional exit to connect the balanced antennas is available, an optional 04:01 current of current (not included) is recommended. The double incorporated metro crossed needles shows Forward and Reverse power as well as the resulting SWR. Pass max. of the meter from 300 to 3000w measurement. A 'Peak and Hold' function makes the meter reading easier. Nutrition requires 12V, max. 200ma. {

{

{

The Palstar AT-2K tuner is a manual antenna tuner for shortwave and 6m. By Using the Three Controls (2x Variable Capacitor, 1x Roller Inductor) You get Very accurate and Precisely Reproduable Tuning Results. Varicps Are Tuneds Via at 6: 1 Reduction, The Smooth-Running Roller inductor via a Big Crank. These components have, According to Its Maximum Allawable Transmitting Power of 2000W PEP, A Very High Voltage Resistance. ENVIGHANCE RANGES FROM 20 to 1500 Ω for Frequencies from 1.8 to 30 MHz, on 6m prevadance is a Little Less.

{

Connect with the Mode Switch Two Different Antennas Either Directly or via Tuner to the Transceiver. An additional output to connect Balanced Antennas is available, an optional 4: 1 Current Balun is Recommended (Not Included). The built-in dual Cross-Needle Meter Shows Forward and Reverse Power As Well As the Resulting Swr. Switch max.Measuring Range of the Metter from 300 to 3000w. A 'Peak and Hold' Function Makes It Easier to Read the Metter. Power Supply Requires 12V, Max. 200ma.

{

{

{

• {
• Tuner {
• DC Cable {
• Manual English {

{

Only The Coax Cable is Needed to Connect Radio and Tuner! No Other Connections necessary.